Jewelry Instructions

DIRECTIONS FOR NECKLACES:

Thread needle with any color thread. Double thread and knot at the end. Leave a tail on the knot, you'll need this after to tie the necklace around the doll. String thread with approx. 8-14 beads depending on the size of the bead. You can test the beads strung around the doll's neck to see if it is too big or too small. Put the correct size around her neck. Tie the string from one end to the other and knot here. I use a dab of glue to make sure the knot is secure.

DIRECTIONS FOR BRACELET:

Same as necklace with fewer beads.

DIRECTIONS FOR EARRINGS:

A) buy straight pins with colored balls on the ends. Take wire cutters and cut the needle portion in half. Use the small pin, now with no point and the colored end and put into her earring holes. I use a little dab of rubber cement to keep this attached to her head. If ever you decide to remove these earrings, you just pull them out and rub off the glue.

B) buy small tiny pins. They come in a pack of like 100 and are about 1/4" long. You can put a bead through the pin. Put a dab of glue on the end of the bead where the pin head it to keep the bead secure. Put the new post earring into her earring holes. You again can use a dab of rubber cement to keep the earring firmly in place.